A pair of new replacement Serrated Vise Jaws for the Reed 3C Vise.

A-2 Tool Steel is Heat Treated to 54-56 Rockwell. The colorful pattern on the serrated jaws happens during the Heat Treating process when nitrogen is used. After Heat Treating, these jaws are surface ground flat and then squared.

A note on the clearance hole for the pin, I did not machine the hole all the way thru, you might have to shorten the pin just a bit, I did not see why a hole should be all the way through just for the pin. This jaw has a 1/2 clearance hole counterbored a 1/2 inch deep. This should clear the pin if it is stuck in your Static and Dynamic jaw supports.

(4x)  5/16:18 Short Head Cap Screws supplied.

Made in the USA.

Length:            5.0 inch       

Width:              1-5/32  inch (1.156)     

Thickness:          1/2 

Distance between screws.  3.0 inch                

Screw Size:      5/16:18